[A6] Trouble with A6 - Already

[vespine at netspace.net.au]

After a few months of owning my A6, I had a similar "ghost in the machine" type 
incident and narrowed it down to a stuck button (I can't even remember which it 
was now), just tapped it a bit to get it going again. That was over a year or 
more ago and I haven't had a single problem since. If it helps you sleep at 
night:-)

-&e.

Quoting Don Gothard <gothard at swbell.net>:

>  Well, I have done a hard reset again, I have followed everything on page
> 267, and all voices, filters, etc show up as tuneok. I have been thru all
> the knobs, switches, etc with in the diagnostics mode again, and everything
> passed again. The only thing that seemed a little funny during the
> diagnostic this time was the ribbon left took a couple of trys before the
> "passed" showed up. Now it appears to be staying in tune one again. So maybe
> it was a stuck parameter on the ribbon but I'm not sure. Guess I'll have to
> keep an eye (an ear??) out and see. Thanks for all the suggestions.
> 
> Don
> 
> 
> > -----Original Message-----
> > From: a6-bounces at roland.code404.com 
> > [mailto:a6-bounces at roland.code404.com] On Behalf Of J.C. Jordan
> > Sent: Sunday, August 15, 2004 11:31 AM
> > To: a6 at code404.com
> > Subject: RE: [A6] Trouble with A6 - Already
> > 
> > you mentioned that the 'e' symbol was lit up when you turn on 
> > the machine, as if it was being edited? when that was 
> > happening to me, i had a stuck button, which caused all kinds 
> > of weirdness. but you said you'd been completely through the 
> > diagnostic? double check.
> > good luck.
> > jc
> > --- Mark Wolinsky <mwolinsky at cox.net> wrote:
> > 
> > > One last thing(that I can think of) is to check  the FM 
> > settings. This 
> > > drove me nuts with different voices not straying in tune. 
> > Turn the osc 
> > > 2 FM knob to access the parameters(at top of  osc 1 group). 
> > Make sure 
> > > all parameters are set to 0. Then hit the NZext sub menu 
> > and 0 out all 
> > > the parameters here. Also have you followed the checks on 
> > page 267 in 
> > > the manual to see if you can isolate the problem to a particular 
> > > voice? You may very well have a real problem but at least 
> > you will be 
> > > able to say you covered all your bases before sending it 
> > back. Good luck.



------------------------------------------------------------
This email was sent from Netspace Webmail: http://www.netspace.net.au