[A6] Programming Help

[Larry Pham]

much appreciated Robert! I will give these settings a try right now.

L
----- Original Message ----- 
From: "Robert van der Kamp" <robnet at wxs.nl>
To: <a6 at code404.com>
Sent: Friday, July 11, 2003 2:17 AM
Subject: Re: [A6] Programming Help


> On Friday 11 July 2003 05:22, Larry Pham wrote:
> > Hey thanks! I kinda got it to work but I definetely need
> > to play around with it some more. I can't get it to
> > trigger the same every time. With every key press the
> > initial lfo speed is diffferent. 
> 
> That's probably because the envelope you use is sensitive to 
> velocity and/or keynote number. Check it's Dyn page. 
> 
> > Any chance you can give
> > me a simple setting example using the envelope method? I
> > would appreciate it as it will give me a better insight
> > on how to use the envelops as a mod souce.
> 
> Okay, this is what I tried with success:
> 
> 1. Create the init program (with Program, NewPrg, Store).
> 
> 2. Turn down Osc2 level in PreFilterMix (we'll be focussing 
> on Osc1 here).
> 
> 3. Disable Mod1 of Osc1 (we want a fresh new Mod).
> 
> 4. Using Mod2 of Osc1, mod Lfo2 to Frequency, using a level 
> of 1.51 and zero offset.
> 
> 5. Set Lfo2 rate to 1.5 Hz. This is the end frequency, when 
> the freq drop is completed. Change to taste (as with all 
> other values). 
> 
> You should now hear the LFO'd tone. Next, the modding of the 
> LFO freq using Env1.
> 
> 6. In Env1, disable (zero) D2 time and R1 time. We want a 
> simple ADSR envelope.
> 
> 7. In Env1, set Attack time fast (2), D1 time to about 2 
> secs and R2 time to about 8 seconds. D1 time is the 
> frequency drop pre-delay, R2 time is the actual drop curve.
> 
> 8. Set Env1 mode to FreeRun (it's in the Trig page), to make 
> sure that the envelope is running its cycle, ignorig 
> keypress or sustain pedal.
> 
> 9. Now go to Lfo2 again and mod its frequency with Env1. I'm 
> using a level of 10.0 (to make my case) and zero offset.
> 
> That should do it.
> To chage the start LFO freq, change the level in step 9. 
> To change the end LFO freq, change the freq in step 5.
> To change the freq drop delay, change the D1 time in step 7.
> To change the freq drop time, change the R2 time in step 7.
> To change the LFO intensity, change the level in step 4.
> 
> Hope this helps,
> Robert
> _______________________________________________
> A6 mailing list
> A6 at code404.com
> http://code404.com/mailman/listinfo/a6