[A6] mix mode question

[Doug Pearson]

At 06:54 AM 3/21/2005, alex prescott wrote:
>encountered this one over the weekend and was unable to come to a conclusion-
>
>when in mix mode, if i have a part that i have configured to be mono, and 
>have turned the voice output on, and the main/aux output to "off", is it 
>possible to choose which voice output the part will go to?
>
>for example, i have a part or two that go out the main outputs, one or two 
>that go out the aux outputs, and i have patched voice outputs 1 and 2 as 
>well for other mix parts that will be in mono.  i was trying to find out 
>if i could send the first mono part to voice output 1, and the second part 
>to voice output two...

Internal Voices in the A6 are hard-wired to the individual voice outs 
(1-16).  For monophonic sounds, that means that when you assign the Mix 
Voice for the sound, it will come out of the individual out corresponding 
to that mix voice number (if a unison monophonic sound, it will also use 
Mix Voice + 1, Mix Voice + 2, etc. [but you couldn't assign a unison-4 
monophonic sound to use, say, voices 2, 4, 6 and 8, only 2,3,4,5, or 
5,6,7,8, etc.]).  However, there is no way to assign a polyphonic sound to 
individual outs, either in mix mode or otherwise.

Selecting the Mix Voice number is the same as selecting the program voice 
number, but when done in mix mode, the parameter will read Mix Voice.

>hope i made sense------

I think so, and that the answer to your question is "yes", but only for 
monophonic patches (which is what you were asking about).

         -Doug
          jasret at mindspring.com