[A6] F1 MIX AGAIN

[Kyle Jarger]

Yannis wrote:

>Well, in the T&T doc it says that the F1 Mix adjusts the level of all three outputs of >filter 1. If this is the case how come it has negative settings as well? What does negative >level mean? Is there something below silence?

I'm guessing its either that 
the negative settings invert the phase of the all of the outputs of F1, so that different combined filter responses can be obtained when the output of F1 is mixed with the out of F2 when the filters are in parallel, 
or (more likely) that the negative settings are just as silent as a zero setting, but allow for more headroom before maxing out when multiple sources are used to control the output level of F1 (for example if an envelope plus a triangle LFO are modulating F1 output level, but the total effect is clipping and maxing out, so that the LFO sounds more like a square wave, if you set the F1 level to a negative number, you'll lower the total level and thus stop the clipping and the LFO sounds triangle again.)

jkjelec

######################################################################
Notice:  This e-mail message and any attachments to it may contain legally privileged confidential information. 
If you are not the intended recipient, you must not review, retransmit, convert to hard copy, copy, use or disseminate 
this e-mail or any attachments. If you have received this e-mail in error, please immediately notify us by return 
e-mail or by telephone at 978-657-9980 and delete this message.  The Resolution(R) System bears the CE Mark and 
is cleared for distribution in the European Union.
It is an Investigational Device in the United States and is not commercially available. 

######################################################################