[A6] Trouble with A6 - Already

[Don Gothard]

Actually this originally happened after having it on for hours. I am aware
of the the warm up time too. It seems to be stable now once again but I will
still keep a close eye on things at this point. 

> -----Original Message-----
> From: a6-bounces at roland.code404.com 
> [mailto:a6-bounces at roland.code404.com] On Behalf Of Larry Pham
> Sent: Sunday, August 15, 2004 5:23 PM
> To: a6 at code404.com
> Subject: Re: [A6] Trouble with A6 - Already
> 
> ... Just to make sure... Do the tuning problems happen when 
> you first start turn on the A6?
> It takes about 5 mins to warm up and I know during that time 
> it will not be in tune.
> 
> 
> 
> ----- Original Message -----
> From: "Don Gothard" <gothard at swbell.net>
> To: <a6 at code404.com>
> Sent: Sunday, August 15, 2004 3:05 PM
> Subject: RE: [A6] Trouble with A6 - Already
> 
> 
> > Well, I have done a hard reset again, I have followed 
> everything on page
> > 267, and all voices, filters, etc show up as tuneok. I have 
> been thru all
> > the knobs, switches, etc with in the diagnostics mode again, and
> everything
> > passed again. The only thing that seemed a little funny during the
> > diagnostic this time was the ribbon left took a couple of 
> trys before the
> > "passed" showed up. Now it appears to be staying in tune 
> one again. So
> maybe
> > it was a stuck parameter on the ribbon but I'm not sure. 
> Guess I'll have
> to
> > keep an eye (an ear??) out and see. Thanks for all the suggestions.
> >
> > Don
> >
> >
> > > -----Original Message-----
> > > From: a6-bounces at roland.code404.com
> > > [mailto:a6-bounces at roland.code404.com] On Behalf Of J.C. Jordan
> > > Sent: Sunday, August 15, 2004 11:31 AM
> > > To: a6 at code404.com
> > > Subject: RE: [A6] Trouble with A6 - Already
> > >
> > > you mentioned that the 'e' symbol was lit up when you turn on
> > > the machine, as if it was being edited? when that was
> > > happening to me, i had a stuck button, which caused all kinds
> > > of weirdness. but you said you'd been completely through the
> > > diagnostic? double check.
> > > good luck.
> > > jc
> > > --- Mark Wolinsky <mwolinsky at cox.net> wrote:
> > >
> > > > One last thing(that I can think of) is to check  the FM
> > > settings. This
> > > > drove me nuts with different voices not straying in tune.
> > > Turn the osc
> > > > 2 FM knob to access the parameters(at top of  osc 1 group).
> > > Make sure
> > > > all parameters are set to 0. Then hit the NZext sub menu
> > > and 0 out all
> > > > the parameters here. Also have you followed the checks on
> > > page 267 in
> > > > the manual to see if you can isolate the problem to a particular
> > > > voice? You may very well have a real problem but at least
> > > you will be
> > > > able to say you covered all your bases before sending it
> > > back. Good luck.
> > > > _______________________________________________
> > > > A6 mailing list
> > > > A6 at roland.code404.com
> > > > http://roland.code404.com/mailman/listinfo/a6
> > > >
> > >
> > >
> > >
> > >
> > > __________________________________
> > > Do you Yahoo!?
> > > Yahoo! Mail Address AutoComplete - You start. We finish.
> > > http://promotions.yahoo.com/new_mail
> > > _______________________________________________
> > > A6 mailing list
> > > A6 at roland.code404.com
> > > http://roland.code404.com/mailman/listinfo/a6
> >
> > _______________________________________________
> > A6 mailing list
> > A6 at roland.code404.com
> > http://roland.code404.com/mailman/listinfo/a6
> 
> 
> _______________________________________________
> A6 mailing list
> A6 at roland.code404.com
> http://roland.code404.com/mailman/listinfo/a6