[A6] A6 Parts Source

[Geoff Moehrke]

Try contacting Paul Lucia @ Alesis/Numark (401) 658-3131

Keep in mind, the procedure for replacing the end cheeks is not as
simple as one might think.  You need to remove some of the panel PCB's
in order to unscrew the endcap from the frame - this means removing all
of the knobs, unscrewing the entire board and then reseating it properly
when finished so as not to misalign any of the buttons.  I have detailed
instructions on how to do this if you're interested I'll dig them up and
forward them to you.  Good luck.

-Geoff Moehrke

>-----Original Message-----
>From: a6-bounces at code404.com [mailto:a6-bounces at code404.com] 
>On Behalf Of Chad Gould
>Sent: Thursday, September 11, 2003 2:26 PM
>To: 'a6 at code404.com'
>Subject: [A6] A6 Parts Source
>
>
>I'd like to know a contact for obtaining plastic endpiece 
>parts for the Andromeda. Now that I have a hardcase, the ends 
>that I've damaged shouldn't crack so much anymore :) so it 
>would be nice to get a replacement. [I don't think I need to 
>send it in for repair, I'm pretty competent with a screwdriver.]
>
>Oh, and the Alesis A6 FAQ link on the "FAQ and Technotes" page 
>is mislinked to a ".pfd" file (not a .pdf). If people from 
>Alesis's web site are still on here, they can easily correct this typo.
>
>I've discovered a bug where patches in multimode will randomly 
>get unintended modulation (as if from the mod wheel), but I 
>haven't quite figured out how this happens... hmmm... 
>__________ CHAD GOULD
>
>_______________________________________________
>A6 mailing list
>A6 at code404.com
>http://code404.com/mailman/listinfo/a6
>
>